And I don’t mean try to move it all by yourself—you’ll need help, at least three or four friends with strong backs. An empty hot tub can weigh between 500 and 1000 pounds. The most important thing is to first devise your plan and route. If you can’t find enough helpers or if the route is too complicated, do yourself a favor and hire professional movers.
Hot Tub Installation 101
What you’ll need
A pickup or moving truck Four-wheeled furniture dollies (at least two) Nylon moving straps Two 8-foot 4x4s Ramp Measuring tape Four strong friends Two or three sheets of ½-inch plywood (if you’ll be moving across grass)
Steps to Move a Hot Tub
How to Pick up a Hot tub
When you’ve procured a truck, a crew, the necessary materials, and assured your route is clear, it’s time to move.
Moving on the flat
With as many helpers as it takes, lift one side of the tub high enough so that you can slip a 4x4 underneath the tub’s edge. Repeat on the opposite side. Next, slide a furniture dolly under one end of the tub between the two 4x4s and slide the second dolly in place opposite the first. Remove the 4x4s. Using moving straps, tightly secure the tub onto the dollies. Position a helper on either side to stabilize the tub and start to slowly roll it toward the truck. Maintain the balance by reassigning helpers as you go. Note: If you happen to be moving across an area of lawn, it’s best to place a sheet of plywood on the grass so the dolly wheels don’t sink into the ground. If you’re moving across an expanse of lawn, you can “leapfrog” the plywood sheets ahead of your progress as you go. When it’s time to push the tub up the ramp into the truck, be careful to keep the dolly wheels on the ramp. Once the tub’s in the truck, secure it by tying it with ratcheting straps to the inside of the truck box. Note: Most rental trucks have rings bolted to the box sides for this purpose. Cover the tub with moving blankets to protect it during the trip.
Moving on the edge
If you can’t find a truck wide enough for your hot tub, you may have to move it upright on its side.
Get half of your crew on one side of the tub. When you’ve raised it, you don’t want to have the weight of the tub resting on the access panels or electrical connections, so plan accordingly. Place a furniture dolly alongside the chosen edge of the tub, and station two people at the dolly. Have everyone lift up the opposite side until the tub’s edge is fully resting on the dolly. Secure the tub to the dolly with straps, and, monitoring the tub’s balance, start to move the tub as described above. Once you have the tub loaded on the truck bed (assuming the truck is a pickup), use straps to secure it so it can’t move from side to side. To protect it, use moving blankets and drive slowly, exercising extra caution on sharp turns. Before leaving, be sure to take with you all the 4x4s, plywood, and anything else that you’ll need to unload and move when you arrive at the tub’s new location. When unloading the tub, make sure to have crew members stabilizing both sides of it as it comes down the ramp. After you’ve wheeled the tub to its new location, reverse the dolly-loading procedure to offload it, and begin the installation. Then have a soak.
